826 nm), a big compressive phosphatase inhibitor stress may appear at the interface of the substrate and as-grown top film on it, and it will gradually release with the increase of the thickness of the film in order to reduce the compression. In our case, with enhancing film thicknesses from 200 to 1,030 nm, the residual stresses decrease
from 0.101 to 0.076. It is indicated that the compressive Ro-3306 stress caused by the lattice mismatch of the CeO2 cap layer and the above GdBCO film can be released when the film thickness comes up to a certain value such as 1,030 nm. It should be noted that a stress conversion appears at the thickness of 1,030 nm. Tensile stresses occur at one location far away from the CeO2 cap layer. Xiong et al. [10] found that the tensile stress appeared when the film thickness reached 1,000 nm.
Zeng et al. [11] have reported similar results. Xiong et al. believed that oxygen vacancies were the reason of the tensile stress [10], while Zeng et al. attributed Epigenetics inhibitor the tensile stress to the more a-axis grains and the bigger surface roughness value with increasing thickness of the film [11]. In our case, we believe that the increase of residual stress for thicker films, such as F1450 and F2100, may be due to the increase of a-axis grains in the GdBCO film, which will cause the tensile stresses in GBCO film’s (a, b) plane. A possible and simple growth model (shown in Figure 6) considering the lattice change is used to explain the variation of the stress with increasing thickness of the film. Figure 6 Schematic diagram of possible growth model for thick GdBCO films on CeO 2 /YSZ/CeO Tangeritin 2 -buffered Ni-W substrates. For the thinner GdBCO film, the film grows with lattice distortion, which results in compressive stresses. As the film thickness increases to a critical thickness, such as 1,030 nm, the GdBCO film grows with a standard lattice. Therefore, the compressive stresses are released. With the further increase of the thickness of GdBCO films, a-axis grains appear. At the same time, the bigger roughness value for thicker films will lead to tilted GdBCO
grains. The two factors result in tensile stress emergence. Oxygen content analysis by XPS XPS is performed to determine the oxygen content of the studied GdBCO films. The XPS measurement is under slot mode, and the analysis area is 700 × 300 μm2. The analysis chamber pressure is less than 5 × 10−9 Torr. Generally, only information from the surface of the film (5 to 10 nm) can be examined by XPS measurement. However, all the films are fabricated under the same conditions except for fabrication time. Hence, the XPS measurement of GdBCO films with different thicknesses is equivalent to the XPS depth profiling measurement of one thicker film. The spectra obtained for O 1s is shown in Figure 7. The O 1 s spectra consist of two peaks. The main peak at E B = 528 to 528.